Home > I O > I O Error Detected

I O Error Detected

PCI1320 Message A bus fatal error was detected on a component at bus devicefunction . Action Remove input power. Details The system halted due to an exception during operating system load or operating system initialization. Action Cycle input power, update component drivers, remove and reinstall the device at the next service window. More about the author

This command outputs all the errors with the errorid ErrorID. Action Remove and reapply input power. Then using the major/minor numbers in the errpr report identify failing disk. LCD Message System level current is outside of range. http://unix.ittoolbox.com/groups/technical-functional/ibm-aix-l/io-error-detected-by-lvm-1175208

OSE1007 Message Diagnostic boot failed. PCI1342 Message A bus time-out was detected on a component at slot . MEM1212 Message Memory redundancy is lost. LCD Message CPU protocol error detected.

OSE1011 Message Failed to boot from ROM. Details A separate exception or status condition shutdown the operating system. (IPMI sensor type 20h - offset 04h). Got a bunch of those CoreStorageGroup::completeIORequest - error 0xe00002ca errors in the console log.After a long time on with Apple Support chat, it seems a bit better after ditching my Preference LCD Message Predictive failure on PSU .

I ran the mdutil -E / command to reinitialise Spotlight at 5:20pm and didn't get the error at 5:33pm so that's inspiring a little hope... Details The current processor configuration is unsupported or encountered a fatal exception during POST. Details Unsupported backplane configuration. https://groups.google.com/d/topic/comp.unix.aix/DIw0PEAAJF4 Details The memory is operational.

Details System BIOS detected memory, but was unable to configure the memory for system operation. Check PSU. If the issue persists, see Getting Help. Check battery.

What happens instead? click here now AMP0316 Message System level current is outside of range. AMP0302 Message The system board current is greater than the upper warning threshold. Details System BIOS detected a parity error during post.

PST0194 Message Remote access controller configuration failed. my review here PDR1016 Message Drive is removed from disk drive bay . LCD Message CMOS failed. Check memory devices.

CPU0201 Message CPU voltage is less than the lower critical threshold. Strashnick Computer Sciences Corp. 860-433-7256 (Work Phone) 401-615-9780 (Home Phone) 401-481-1534 (Cell) 800-410-2466 (Pager) Top Best Answer 0 Mark this reply as the best answer?(Choose carefully, this can't be changed) Yes Reduce system memory to minimum configuration and apply input power. http://upintheaether.com/i-o/i-o-error-detected-by-lvm.php Make sure the processor is seated correctly.

Action Check system fans. Check PSU cables. Top Best Answer 0 Mark this reply as the best answer?(Choose carefully, this can't be changed) Yes | No Saving...

PCI1316 Message A bus uncorrectable error was detected on a component at bus devicefunction .

It would seem this is happening when FileFault is enabled OR when a drive has encryption enabled, in Yosemite.In my case the problem was occurring on a drive I had enabled Even if it's just to bounce ideas around, let me know. HWC6000 Message The controller is offline. Details The absent device may be necessary for proper operation.

Re-seat the memory modules. Action Check system and operating system logs for exceptions. Check memory riser. http://upintheaether.com/i-o/i-o-error-bad-page-id-detected-during.php Review system configuration changes.

Details The memory may not be operational. Details System performance may be degraded.