Hp Psc 1400 Cartridge Error
Pull the door away from the product to remove it. Please try again later. If the carriage is stuck on the right side of the product, move the carriage to the left side of the product. or it's affiliates. http://upintheaether.com/hp-psc/hp-psc-1400-printer-cartridge-error.php
advice? » Thread Tools Show Printable Version Download Thread Search this Thread Advanced Search Posting Rules You may not post new threads You may not post replies You may not post drop-down list, click Restart, and then click OK. Double-click Program Files. Solution three: Service the All-in-One If you have completed all the steps and are still experiencing a problem, continue to the Service the All-in-One section at the end of this document.
If the issue persists, continue with the next solution. Wait until the Power light () stops blinking. Removing the front panel protector Front panel overlay correctly installed Attaching the front panel overlay Step 4 Perform a Power Cycle on the unit. note: If the product works properly when plugged directly into a wall outlet while disconnected from any power strips or surge suppressors, the power strip or surge suppressor may not be
If it is open, close it. Windows 7 On the Windows taskbar, click the Windows icon (), click the Right Arrow button (), and then click Restart. Solutions Solution one: Load paper, and then resume the print job If the paper tray is empty, load more paper into the paper tray. Figure 11: Open the cartridge access door Figure 12: The carriage in the center of the product When the carriage stops moving, disconnect the power cord from the rear of the
The reset is then complete. Double-click HP. If these steps resolved the issue, there is no need to continue troubleshooting. Both cartridges fit perfectly but I haven't been able to get it to perform since replacing the color.
Clean the contacts in the carriage slot for the problem cartridge. http://www.techsupportforum.com/forums/f109/hp-psc-1400-stalled-on-check-cartridge-357139.html WARNING: Make sure that the power cord is disconnected from the product to avoid an electrical shock. Click the Features tab. Solution two: Cancel the task Press the Cancel button () on the control panel.
If the Scan button is pressed and hold down while pressing the Start Black Copy or Start Color Copy buttons, a copy will be created in Fast mode. this content Double-click Digital Imaging. Figure 39: Load the alignment page Close the scanner lid while holding the alignment page in place. Voltage and amperage specifications printed on the power supply Voltage and amperage requirements printed on the HP product In this example, the voltage (+32 V) and the amperage (2000 mA) from
Show more Language: English Content location: United States Restricted Mode: Off History Help Loading... Step 2 Remove the media from the paper tray and verify that the media meets the specifications for the unit. Loading...
Double-click Local Disc (C:).
When the lights begin to flash, press and hold the On and Paper Size buttons. Open the cartridge access door. Sign in to add this to Watch Later Add to Loading playlists... Turn on the unit.
When the On light is flashing, release the On and Paper Size buttons. To do so, follow these steps: Turn off the unit. An alignment page prints within a minute. check over here Press the Power button () to turn on the product.
Figure 1: Control panel with the lights indicated 1 - Power light 2 - Check Paper light 3 - Check Cartridge light 4 - Number of Copies / Error (E) 5