Home > Hp Psc > Hp All In One Print Cartridge Error

Hp All In One Print Cartridge Error

Contents

Step one: Perform a power reset Press the On/Resume button () to turn on the product. If these steps resolved the issue, you do not need to continue troubleshooting. With the power on, disconnect the power cord from the rear of the product. If these steps resolved the issue, you do not need to continue troubleshooting. http://upintheaether.com/hp-psc/hp-psc-1350-print-cartridge-error.php

Doing so can cause bad electrical connections, clogged ink nozzles, or poor print quality. The sequence must be completed within ten seconds. If the product does not scan, follow the same steps and try a different wall outlet. Insert the black cartridge in the slot on the right. news

Hp Psc 1350 Check Print Cartridge

Pulling paper from inside the front cover can cause mechanical damage to the product. This video shows how to clear a paper jam from the All-in-One Click here to see this video in full screen on YouTube. Step one: Use genuine HP cartridges Make sure that the cartridges are compatible with your printer. With the power on, disconnect the power cord from the rear of the product.

Wait until the carriage is idle and silent before you continue. Disconnect the USB cable from the rear of the product. Wait until the carriage is idle and silent before continuing. Hp Psc 1210 Check Print Cartridge Error Cleaning products designed for cleaning electronics can be obtained from local office supply or electronics stores.

note: If the alignment page fails to print, repeat the button-press sequence in this step. Hp Psc 1315 Check Printer Cartridge Error Figure : Print carriage Figure : Clean the gold-colored contacts in the print carriage Step 5: Repeat reseating and cleaning steps If the print cartridge light keeps flashing, repeat steps 3 When the lights begin to blink, press and hold both the On/Resume button () and the Paper Size button at the same time. The printer does not print, and one of the following error messages is displayed on the printer control panel: At least one of the cartridges has a problem Non-HP Cartridges installed

If the ink cartridge is outside the printer for too long, the ink can dry and clog the nozzles. How To Reset Hp Psc 1410 Printer The tricolor cartridge goes into the left carriage slot. Follow these steps to determine which cartridge is defective, and then remove and replace that cartridge. Before loading paper in the tray, hold the stack of paper, and then tap the bottom edge on a flat surface so that the stack is even on all sides.

Hp Psc 1315 Check Printer Cartridge Error

Step one: Make sure that the carriage can move freely Press the On/Resume button () to turn on the product. http://h30434.www3.hp.com/t5/LaserJet-Printing/Remove-and-check-print-cartridge-error-sign/td-p/1181031 Solution seven: Identify and then replace the problem cartridge The error message might indicate a specific cartridge has caused the error. Hp Psc 1350 Check Print Cartridge Paper was added to a stack already in the tray while the HP product was printing. Hp Psc 1350 Troubleshooting The rear access door might not be closed or is not locked into place.

Damaged or dirty paper rollers. http://upintheaether.com/hp-psc/hp-psc-1350-error-print-cartridge.php If these steps resolved the issue, you do not need to continue troubleshooting. Open the cartridge access door and wait a moment for the cartridges to come to the center. Lightly moisten the lint-free material with distilled water and squeeze out any excess water. Hp Psc 1410 Check Print Cartridge Flashing

If the issue persists, continue to the next solution. Step two: Print a self-test report Follow these steps to print a self-test report. Help! http://upintheaether.com/hp-psc/hp-psc-1200-print-cartridge-error.php Wait until the printer is idle and silent before you continue.

Step two: Print a self-test report Follow these steps to print a self-test report. Hp Psc 1210 Troubleshooting If the test page does not print, continue with the next solution. Disconnect the USB cable from the rear of the product.

Wird geladen...

Step one: Remove the cartridges Press the On/Resume button () to turn on the product. Thank you for posting. Check your product warranty to determine if your product is still under warranty, and then go to Contact HP Support to schedule a repair or replacement. Hp Printer Cartridge Error Override If your cartridges are not compatible, replace them with compatible HP cartridges, and then follow the steps in this document to install new cartridges.

If these steps resolved the issue, you do not need to continue troubleshooting. If the printer did not print an alignment page, follow these steps: On the printer control panel, press the Down Arrow () to select Tools, and then press OK. Figure : Locate the slots on the sides of the printer Slide your fingers into the two slots, and then gently lift up to open the cartridge access door. navigate here Sheets of paper or a paper towel to rest the ink cartridge on during cleaning.

Figure : Close the cartridge access door Follow the instructions on the control panel to start the cartridge alignment. Push down on the top of the problem cartridge to release it, and then pull it toward you to remove it from its slot. Do not leave a cartridge outside the printer for more than 30 minutes. If the issue persists, continue to the next step.

If the issue persists, continue to the next solution. Solution four: Remove and reinstall the cartridges Follow these steps to make sure that both cartridges are installed and seated correctly. Click Download next to the full feature driver (recommended), or click Basic Drivers for other driver options. Options Mark as New Bookmark Subscribe Subscribe to RSS Feed Highlight Print Email to a Friend Report Inappropriate Content ‎08-19-2010 12:32 PM I tried your suggestion to no avail!

This video shows how to print a test page Click here to see this video in full screen on YouTube. Plug the power cord back into the wall outlet. Insert the paper into the paper tray print side down until it stops. Reconnect the power cord to the back of the printer.