Hp Officejet 7410 Error 388
Thank you! however, there are similar code for other Hp printer. Retry the fax transmission when the line is no longer busy. 314 The local machine attempted to initiate a remote diagnostic session, but detected that remote diagnostics are disabled on the This is a common error when attempting to fax over VoIP, such as MagicJack. navigate here
I have set the J6480 touse the same line that our other fax machine used before it died on Tuesday, (Ricoh fax/copier). Disable ECM. Reply 0 0 « Message Listing « Previous Topic Next Topic » Related Documents HP Printers - Using HP Diagnostic Tools for HP Printers in WindowsHP Printers - After Windows 10 Configure the local fax machine to use a slower reception speed.
If the error persists, and error correction is in use for the fax session, disable ECM. Error Code(s) Definitions/Causes Solutions 238 239 ECM 240 ECM 241 ECM The sending fax machine sent an unexpected communication. Reply 0 Fax error code 388 - how to resolve 01-22-2013 11:59 AM @UteMtnI would take a look at the document below it describes what every fax error code means.
Push the menu/setup button ->Select Advanced fax setup-> press ok/Enter->Scroll Down to Error Correction mode(ECM) and highlight -> press ok/Enter->Select turn OFF-> press ok/Enter.At Last Press Cancel to quit the menu. Confirm that the sender is not inadvertently attempting to poll the local machine for a document, instead of sending to the local machine. Retry the fax reception when telephone line conditions have improved. HP OfficeJet 7410 All-In-One... 14 Answers Cannot delete print job HP PSC 1315 All-In-One InkJet... 11 Answers Free download driver HP PSC 1410 HP PSC 1410 All-In-One InkJet...
This error might be associated with bad line conditions or might indicate a problem with the fax's modem. I fed an envelope into the printer as per the icon but the address is not printing in the correct position on nthe envelope ? Melde dich bei YouTube an, damit dein Feedback gezählt wird. https://h30434.www3.hp.com/t5/Scanning-Faxing-and-Copying/Error-388-when-trying-to-fax-with-HP-Officejet-6700/td-p/2394033 Enable the remote diagnostics capability on the local machine, if available.
or it's affiliates. Such opinions may not be accurate and they are to be used at your own risk. Hate not being able to fax. Turn OFF the Error Correction mode(ECM).Steps to do.
Oct 16, 2016 | HP DeskJet 970cxi InkJet Printer Related Topics: HP Printers & Copiers View All » 312 people viewed this question Ask a Question Usually answered in minutes! Wird verarbeitet... Turn both the sending and the receiving machine off for ten seconds, turn them on, and then try sending again. The remote user canceled the fax transmission by pressing the Stop key immediately prior to, or just as the local machine answered the call.
If the local machine received several pages of a larger document successfully, ask the remote user to send the document in several smaller parts. 253 The remote machine attempted to initiate check over here Call the telephone provider if line conditions fail to improve.Error 403:DefinitionDuring a V.34 transmission, the local machine is unable to connect (handshake) with the remote machine and is consequently unable to If the document is large, ask the remote user to re-send the document as two or more smaller documents. I have dial tone & I've set the fax speed to slow Solved!
If not, reconfigure the local machine for a normal fax transmission. Error Code(s) Definitions/Causes Solutions 300 The fax session completed without errors. Make sure paper is loaded correctly, paper is not jammed within the machine, and any other system errors have been cleared. 232 233 234 235 ECM 236 ECM 237 A communication
Share on Facebook Share on Twitter Share on Google+ Share on Pinterest Share by Email × Question about HP Printers & Copiers Open Question I tried to fax from HP officejet
Resend at a lower resolution. Interpreting fax send error codes This table contains fax send error codes. There was a communication error with the sending fax machine. Remote diagnostics cannot occur between machines with incompatible remote versions. 316 The local machine is set to initiate document transmission, but detected that the remote machine is not able to receive
These errors can occur if the phone lines in the area to be faxed are old or there is noise (static on the phone line). Retry the fax reception when telephone line conditions have improved. Configure the remote machine for reception. weblink Anmelden 17 Wird geladen...
Select a slower reception speed.