Home > Hp Laserjet > Hp Laserjet 51.1 Error

Hp Laserjet 51.1 Error


X PRINTER ERROR a loss of beam detects occurred. Home | Error Codes | Hp Printers | Toner Cartridges | Hp Printer Accessories | Hp Plotters Copyright © 2011 Advanced Laser Services, Inc. Replace the scanner ass'yHP COLOR LASER PRINTER 4600, 5500 ERROR 51.1, 51.21. This is done by turning on the laser when it is focused off the image drum and onto the beam detect mirror which again sends it to the beam detection sensor navigate here

System error 65:03 Generic input/output port communication problem. Articles Forum New Posts FAQ Calendar Community Groups Forum Actions Mark Forums Read Quick Links Today's Posts View Site Leaders Who's Online Blogs Advanced Search Forum Printer Forums Hewlett Packard Laserjets Reset the maintenance count on an HP LaserJet 4000, 4050, 4100, 5000 "The Short Cut Method" 1. A 5 mW laser can slowly damage your eyes and eventually cause blindness without you even knowing it – don’t play with the laser.” To contact Steve Geishirt, call (800) http://www.printertechs.com/printer-troubleshooting/401-51-01-51-1-error-hp-laserjet-4100-laser-scanner-failure

51.10 Error P3015

They said if I knew exactly what part of the scanner was broken, I could order that instead of the entire scanner. Same-day on-site HP LaserJet Printer service error code repairs in L.A and OC! Press the up arrow (Navigation) button until the message New Maintenance Kit appears on the control panel display. 7.

Turn the power off and wait 30 seconds and turn the power back on. 3. One of the questions is whether the feedback of this unit measures the intensity of the beam or not. System error 61:04 Firmware error. Hp Laserjet P3015 Error Codes The Weak Link The weak link in relation to this 51.1 error revolves around the laser, beam detection loop.

The one I ran into it was right on the display and the machine wouldn't do anything. Hp P3015 Laser Scanner Assembly So I called HP and they told me the part was $281, ouch! After installing a maintenance kit, reset the maintenance count to zero by: 1. Once the control panel overlay is removed, use a flat-blade screwdriver as shown in picture below to release the retaining clip from each side of the control panel, then rotate the

it will take me 4 to 5 days to replace this laser because my company will order this, Where? 51.10 Error Hp 4250 Reply With Quote Quick Navigation Hewlett Packard Laserjets Top Site Areas Settings Private Messages Subscriptions Who's Online Search Forums Forums Home Forums Printer Forums Hewlett Packard Laserjets All Other Laser Printers This content is provided “AS IS” and is subject to change or removal at any time. Has anyone encounter this.

Hp P3015 Laser Scanner Assembly

Control panel 1. http://www.imagesourcemag.com/ism-article/511-errors-4100-printers If the FFC is not correctly reconnected, a 51.1 ERROR will appear on the control-panel display. 4.  Remove four screws. 5. 51.10 Error P3015 Error code K - No Black Color.2. Error 51.10 Hp Laserjet P3015 Solution HP LaserJet Printer maintenance kits should be replaced at every 200,000 to 350,000 pages to avoid print defects and paper jam problems.

Exit service mode by pressing the GO button. Clearing the Maintenance Count and Service Message on LaserJet 5Si How to reset printer maintenance count on HP LaserJet 5si After check over here Reseat the connectors between the laser/scanner and the DC controller PCA (J83 and J84) 4. The errors appear to be intermittent, separated by 1000s of pages, or as little as a hundred. We repair HP Laser Jet printer with service error codes and reset laser printer maintenance kit error messages! Hp Laserjet P3015 Laser Scanner Assembly Replacement

It takes a lot of time and effort to put these articles together. System error 42:10 A problem has occurred with the Scan-Axis motor. Keep up the good work mate and I promise to visit your site more typically. http://upintheaether.com/hp-laserjet/hp-laserjet-error-64.php Bad cable from laser scanner ass'y to D.C.

We'll preserve you posted. Hp P4015 Laser Scanner Reply With Quote 03-29-2005,09:03 AM #5 Brian View Profile View Forum Posts View Blog Entries View Articles Senior Member Join Date Dec 2004 Posts 217 I've seen this error a few Replace laser scanner ass'y.3.

Defective DC controller. 4.

If the error persists, replace the DC controller. Press the checkmark button once. (Note: on LaserJet's 4200, 4300, 9000 you can hold down the checkmark button as you turn the power on and then wait for the three LEDs If the message persists after exiting help, turn the device off and then on.4. 51.10 Error Hp 9050 Defective D.C.

System error 73:04 Server error. Replace the ECU. We stock HP LaserJet maintenance Kits for fast onsite printer service in Los Angeles, Orange County & San Bernardino! http://upintheaether.com/hp-laserjet/hp-laserjet-error-52.php They both bounce off the same six-sided spinning mirror, optics, and deflection mirror in the laser scanner unit.

HP LASER PRINTERS 3015/3020/3030MFP 1. Remove one screw, and then slide the formatter cover toward the back of the product to release it. 2. System error 62:03 Parallel port communication problem System error 63:03 LAN card communication problem. by Herfy on Feb 24, 2008 at 10:02pm Add comment Please sign in to comment Please sign in to comment HP DesignJet 30 Buy discount ink Buy this printer More HP

In the 4000, for instance, when printing 1200 dpi, the drum motor needs to take twice as many steps as it did in 600 dpi to create the 1200 lines (down System error 43:11 The Vacuum fan is not detected. This is due to the many different formatter board revisions. controller board.HP COLOR LASER PRINTER 4600, 5500 ERROR 51.X01.

Error code Y - No Yellow color HP COLOR LASER PRINTER 8500 1. Defective laser scanner assembly. 4. If someone knows about this message, please help me, Thank you!by the way, I'm new here in fixyourownprinter... NOTE: Don't remove the 3 screws on the top cover of the laser scanner, and don't loosen the Allen screw at the rear of the scanner assembly.