Home > Hp Deskjet > Hp 5550c Lamp Error

Hp 5550c Lamp Error

Contents

Search all support All Support Software, Drivers and Updates Troubleshooting How to Product Information User Guides Cancel Example: “Laserjet P1102w driver” or “HP Pavilion 17-f002na will not turn on” Loading Results Issue: The Power light and the Resume light are on In this error condition, the following light pattern displays on the product control panel: Print Cartridge status light: Off Resume light: Lights are behaving normally.any ideas,ThanksMichael by Anonymous on Dec 16, 2007 at 11:14am Add comment Please sign in to comment 0 Have you cleaned the contacts in then carriage?If you print by unknown on Jun 1, 2007 at 8:40pm Add comment Please sign in to comment 0 5550 cartridges are easy to refill, I get Stratitec kits at Sam's Club.You can find

Both the power and the orange feed light are flashing. If the carriage is stuck on the right side of the product, move the carriage to the left side of the product. If the test page does not print, continue with the next solution. NOTE: If you find obstructions in the paper path, skip to the section on cleaning the rollers.

Hp 5550 Print Cartridge Status Light Is Flashing

Remove the rear access door. HP Scanjet 5400 Disconnect the USB, ADF, and power cables from the back of the scanner. The computer does not read it and I don't have a icon or program for it... Apply a moderate amount of pressure to remove any dust or dirt buildup.

I have removed the cartridges and powered up, let the printer carry out its` tests, then opened the lid and re-installed the cartridges and shut the lid, the carriage moves to Also please exercise your best judgment when posting in the forums--revealing personal information such as your e-mail address, telephone number, and address is not recommended. Wait until the carriage stops moving and is silent before proceeding. Hp Deskjet 5550 All Lights Blinking Very helpful Somewhat helpful Not helpful End of contentUnited StatesHP WorldwideStart of Country / Region Selector contentSelect Your Country/Region and LanguageClick or use the tab key to select your country

  • How to print a self-test report Make sure that plain white paper is loaded in the input tray. While holding the Power button, press the Resume button () four times. Go to HP SureSupply . http://h30434.www3.hp.com/t5/Inkjet-Printing/deskjet-5550-resume-amp-power-lights-blinking/td-p/931543 Solution one: Check for missing cartridges Follow these steps to check for missing cartridges, and insert cartridges if necessary.

    Tap the stack of paper on a flat surface to align the edges. Hp Deskjet 5550 Flashing Ink Light CloseEnter your product number(e.g. Do not use paper that has previously been printed on. Step two: Insert cartridges Follow these steps to insert a cartridge.

    Hp Deskjet 5550 Manual

    I have not tried a parallel connection.TYbaj - unknown 0 On my previous message:I'm using a generic ink cartridge and I keep getting window reminders that something is amiss with my When I print the same document on plain paper, the rectangle does not appear. Hp 5550 Print Cartridge Status Light Is Flashing He is using a USB cable to a Dell Latitude D800. Hp Deskjet 5550 Printer Driver The product lights might flash and the carriage might move.

    Solution Follow these steps in the order presented to resolve the issue. If any torn pieces of paper remain inside the product, more jams are likely to occur. by efinigan on Apr 21, 2007 at 11:05am Add comment Please sign in to comment Hey efinigan--I've been trying to do the same thing you worked with Stephen on to clean Wait until the carriage is idle and silent before proceeding. Hp Deskjet 5550 Troubleshooting Guide

    While holding the Power button, press the Resume button () four times. Does anyone know where I can get a replacement? Apply a moderate amount of pressure to remove any dust or dirt buildup. If the test page does not print, continue with the next solution.

    but it only supports 300 dpi... Hp Deskjet 5550 Carriage Stuck If the issue persists, continue to the next solution. We do however need to replace this fitting, so if there are any suggestions please let me know.Thanks.Will.

    Reply 0 0 veszely Top Student Posts: 7 Member Since: ‎03-09-2012 Message 4 of 6 (5,107 Views) Report Inappropriate Content Re: HP Deskjet 5550 with Cartridge status BLINKING, power light ON.

    During a successful base unit self test, the scanner will do the following: The scanning lamp will light up. Figure : Insert the cartridge Close the cartridge latch. If these steps resolved the issue, and the test page prints, there is no need to continue troubleshooting. Hp Deskjet 5550 Won't Print Sometimes a service station will fail in a way where the sled does not retract fully, if that failure happens when the carriage is parked then the carriage will usually not

    Before it totally quit printing (with a new #56) it printed 3 pages but left out lines in different locations on each page. Step one: Remove the cartridges Press the Power button () to turn on the product. Solution six: Service the printer If you have completed all the steps listed above and are still experiencing a problem, continue to the Service the printer section at the end of To end the self test, set the power switch to the Off position.

    If these steps resolved the issue, and the test page prints, there is no need to continue troubleshooting. Reconnect the power cord to the rear of the product. Raise the cartridge latch. Solution No action is required.

    Reconnect the power cord to the rear of the product. I'm sure I deleted something somewhere at one time. And when it's turned back on, that whirring sound occurs ... Gather the following materials: A clean, lint-free cloth, or any cloth that will not come apart or leave fibers Distilled, filtered, or bottled water (tap water might damage the product) A

    Sorry, there was a problem flagging this post. If these steps resolved the issue, you do not need to continue troubleshooting. Apply a moderate amount of pressure to remove any dust or dirt buildup. If the test page does not print, continue with the next solution.

    The same part is used in other HP machines including the DeskJet 3820 and OfficeJet V40.Then there was a different symptom, paper fed in and the carriage moved over it, then This worked a couple times. by mahbuban on Dec 21, 2007 at 8:24am Add comment Please sign in to comment 0 Click on the crossed tools to the right of my name to send an email The self-test report prints.

    Is there any way I could attach a photo to my post to show exactly what's gone wrong? If the issue persists, continue with the next solution. Step one: Remove loose paper from the tray Remove any loose sheets of paper from the input tray and the output tray. Step two: Print a self-test report Print a self-test report to make sure that the hardware functions correctly.

    by Bert on Jun 14, 2005 at 3:17pm Add comment Please sign in to comment 1 That indicates a bad cartridge, if you open the top of the printer do the