Home > Fax Error > Hp Officejet 6310 Fax Error 387

Hp Officejet 6310 Fax Error 387

Contents

This might occur naturally depending on when the fax session is terminated. Retry the fax reception when telephone line conditions have improved. Found that out this week. This prevented the fax from receiving any more pages, and caused it to terminate the session prematurely. navigate here

Complementary Content Discussion Boards Open Menu Discussion Boards Open Menu Welcome to the Forum! You may NOT copy or distribute the content that appears on this site without written permission from Fixya Ltd. © 2005-2015, Fixya, Ltd. However, the remote diagnostic versions that are supported by the two machines are incompatible. Learn How to Post and More  Community News  Best of the Community Blog  Notebooks Notebook Operating System and Recovery  Notebook Boot and Lockup  Notebook Wireless and Networking  Notebook Audio  Notebook Video, http://support.hp.com/us-en/document/buu02549

Fax Error Code

Have tried faxing to this number at various times throughout the day. Make sure the remote machine can accept and use polling. Error Code(s) Definitions/Causes Solutions 386 387 388 389 390 391 392 393 394 395 There is too much noise on the line for a valid connection between two fax machines to Symptom of error:

Error message pops up "hp officejet 6310 error codes list" System Performance becomes slow/sluggish.

Try the fax when telephone line conditions have improved. 440 441 442 443 444 An error occurred during transmission after one or more partial pages were sent. Confirm that the remote user wants to initiate a poll transmission. Retry the fax reception when telephone line conditions have improved. Hp Fax Error 346 The remote machine encountered an incompatible feature causing it to terminate the session.

No action required 221 The user pressed the Stop key, causing the fax session to be prematurely terminated. If not, reconfigure the local machine for a normal fax transmission. There might be no solution because the remote machine could be defective. 381 ECM The remote machine failed to respond to a fax command from the local machine because the connection http://h30434.www3.hp.com/t5/Scanning-Faxing-and-Copying/fax-error-code-350/td-p/4864647 However, the ability to send the entire document improves. 329 330 331 The remote machine reported that one or more pages were received (non-ECM mode) with excessive errors.

To verify I suggest trying a different line or another fax machine on that line to isolate the problem.Also what type of fax line do you have? Ecm Setting On Fax The call-waiting service can cause this error. Learn How to Post and More  Community News  Best of the Community Blog  Notebooks Notebook Operating System and Recovery  Notebook Boot and Lockup  Notebook Wireless and Networking  Notebook Audio  Notebook Video, Ask Anonymously Popular Products HP Officejet 5610 All-In-One InkJet Printer 1 Questions Canon PIXMA MP160 All-In-One InkJet Printer 6 Questions HP DeskJet F380 All-In-One Printer -2 Questions Canon PIXMA MP150 All-In-One

Hp Fax Error Code 350

Brother MFC 240C... The call-waiting service can cause this error. Fax Error Code Have the sender send at a lower resolution. How To Disable Ecm On Hp Fax Machine Confirm that the local user really wants to attempt a poll reception.

Remote diagnostics cannot occur between machines with incompatible remote versions. http://upintheaether.com/fax-error/hp-officejet-6310-fax-error-351.php Kind Regards,Dragon-Fur Reply 0 0 khasymjuda3 Student Posts: 1 Member Since: ‎08-01-2016 Message 3 of 4 (486 Views) Report Inappropriate Content Re: fax error code 350 Options Mark as New Bookmark First Time Here? Retry the fax reception when telephone line conditions have improved. Error 344

Disclaimer The steps given below need to be followed under supervision of a Technical Expert. Reply 0 Reply 0 0 Rainbow7000 HP Support Agent Posts: 14,928 Member Since: ‎09-02-2013 Message 2 of 4 (1,453 Views) Report Inappropriate Content Re: HP Officejet 6700 Premium Faxing Error 350 Support Forum Join the conversation! http://upintheaether.com/fax-error/hp-officejet-6310-error-403.php Cause of Error: Internal system conflict.

Set the local machine to receive at a lower transmission speed. Fax Error Codes Ricoh In some cases this error can occur if the other fax machine is using a fax format incompatible with the HP fax. 422 423 A handshaking (connection) error occurred at some These errors can occur if the phone lines in the area to be faxed are old or there is noise (static on the phone line).

Retry the fax reception when telephone line conditions have improved.

Otherwise, ask the sender to remove the fax number from the diagnostic check. 226 The remote machine attempted to initiate a remote diagnostic session with this machine. This error is very rare because normally a remote machine does not answer if it cannot receive a document. The receiving fax machine is an older silent fax machine. Hp Fax Communication Error 37 On many fax machines, it is possible to accidentally initiate a fax reception in the following cases: There is no paper in the machine.

The remote machine disconnected immediately before sending any further fax tones or T.30 frames. Reply 0 0 Rainbow7000 HP Support Agent Posts: 14,928 Member Since: ‎09-02-2013 Message 4 of 4 (1,411 Views) Report Inappropriate Content Re: HP Officejet 6700 Premium Faxing Error 350 Options Mark Reply 0 Reply 0 0 Binary_Zen PhD Student Posts: 821 Member Since: ‎08-12-2009 Message 2 of 2 (2,372 Views) Report Inappropriate Content Re: HP 6500A plus recieve error code 252 and http://upintheaether.com/fax-error/hp-officejet-6310-error-244.php Follow the steps given below to resolve the issue.

Ask the remote machine user to send at a lower resolution setting. The click, heard for an incoming call, is actually a momentary disconnect of the line. Retry the transmission. The call-waiting service can cause this error.

Or just drag it here! The noise problem might go away Prev12Next » Not finding what you are looking for? Question about HP OfficeJet Printers & Copiers 1 Answer I am trying to send a fax error 387 is showing up i am trying to send a fax error 387 is Is this on my end or the receivers end.Could fax speed be an issue?

Try turning on Silent Detect in the Fax settings. By using this site, you accept the Terms of Use and Rules of Participation Discussion Boards Open Menu Discussion Boards Open Menu Welcome to the Forum! I lowered the speed and had some success. Try the fax when telephone line conditions have improved.

Depending on your printer, a fax error code might display on the printer control panel or on a fax history report. However, the ability to send the entire document will be improved.Try sending at a lower transmission speed.============================================================================Possible Underlying causes:Poor phone line condition. Thank you! Register · Log In HP Support Forum Home > Printers > Scanning / Faxing > HP 6500A plus recieve error code 252 and 232 when recieving ... Call the telephone provider if line conditions fail to improve. 291 292 The received fax could not be stored.

You may NOT copy or distribute the content that appears on this site without written permission from Fixya Ltd. © 2005-2015, Fixya, Ltd. Or just drag it here!