Home > Fax Error > Hp Officejet 5610 Fax Error

Hp Officejet 5610 Fax Error

Contents

Follow the steps listed below to download and install the firmware upgrade applicable to your model: Visit the HP Support and Drivers Home page. Reply 0 0 Cheetah12 Retired Posts: 3,707 Member Since: ‎11-04-2013 Message 6 of 7 (10,782 Views) Report Inappropriate Content Re: i am trying to fax but received a message with an Any other suggestions? note: Phone line quality is the most common reason for intermittent fax failures. http://upintheaether.com/fax-error/hp-officejet-5610-error-388.php

Showing results for  Search instead for  Do you mean  or Post new question Question Reply Topic Options Subscribe Mark Topic as New Mark Topic as Read Float this Topic to the Confirm that the remote caller is a fax machine and not a voice call. If faxes still cannot be sent, skip to the section Faxes cannot be sent or received or the problem cannot be determined. Step 2: Check the connections Check the cable connections following the directions listed below: Consult the following document to learn how to connect your HP fax product to an analog line, why not try these out

Hp Fax Error 358

i just reduced my line speed.to do the "REDUCED" line speed, I went to ADVANCED FAX SETTINGs in my menu and choose LINE SPEED. The call-waiting service can cause this error. If this does not occur, your HP Fax is not detecting the tones from other fax machine.

Try the fax when telephone line conditions have improved. In the unlikely event that maybe something was missed here is the definition and solution for error code 349 and 351. I have also set a fax to your test fax and it came back ok. Hp Fax Error 322 By using this site, you accept the Terms of Use and Rules of Participation Discussion Boards Open Menu Discussion Boards Open Menu Welcome to the Forum!

HP, get your @#$%[email protected]#$$^ together. Fax Error 388 Error Code(s) Definitions/Causes Solutions 300 The fax session completed without errors. The remote user pressed the Stop key while the reception was in progress. http://h30434.www3.hp.com/t5/Scanning-Faxing-and-Copying/what-is-communication-error-321/td-p/1652593 I have tested it and am able to receive faxes but get error 388 when I try to send out a fax.

I had older and "cheaper" HP's and the fax transmission always worked. How To Disable Ecm On Hp Fax Machine Error Code(s) Definitions/Causes Solutions 238 239 ECM 240 ECM 241 ECM The sending fax machine sent an unexpected communication. This phone will be used for testing the phone line and different faxing options. Once this is done, please test the sending and receiving functions of the HP fax product.

Fax Error 388

Try the troubleshooting steps and check if issue is reolved.http://support.hp.com/in-en/document/buu02549 Reply 0 0 drhigg Honor Student Posts: 2 Member Since: ‎08-17-2015 Message 4 of 8 (1,009 Views) Report Inappropriate Content Re: http://h30434.www3.hp.com/t5/Scanning-Faxing-and-Copying/FAX-Error-Codes-349-and-351/td-p/3053911 Try the fax when telephone line conditions have improved. Hp Fax Error 358 View Solution. Hp Fax Error 321 If it is possible to send and receive faxes after disconnecting the other devices, add these devices back one at a time to find out which device was causing the failure.

I don't have the luxury o obtaining anothe service provider Seems to eme that HP shoul be able to fix this problem at their end. http://upintheaether.com/fax-error/hp-officejet-5610-fax-error-388.php Search the Community Entire ForumThis CategoryThis BoardUsers turn on suggested results Auto-suggest helps you quickly narrow down your search results by suggesting First Time Here? This is usually caused by one of the following reasons: The user called the wrong number. Hp Fax Error 344

This error typically occurs when the receiving fax disconnects after receiving part of a page. Errors might still occur, and might result in a degraded image quality on the received page. Step 2: Testing the phone line and phone cable This step is aimed at testing both the phone line and the phone cable. his comment is here Reply 2 2 Wawa Tutor Posts: 12 Member Since: ‎12-18-2009 Message 3 of 8 (29,195 Views) Report Inappropriate Content Re: HP Officejet Pro 8500 A910 error 344 Options Mark as New

Make sure that the appropriate option between Tone Dialing and Pulse Dialing is set on your HP Fax product depending on your phone service provider or PBX. Hp Fax Error 350 note: Some HP All-in-One models allow to change the fax settings from the software. Remote diagnostics cannot occur between machines with incompatible remote versions.

This occurs when the line is disconnected or if line conditions degrade during the session.

If not, reconfigure the local machine for a normal fax transmission. Reconnect the power cord. Configure the machine to start reception at a lower speed. Fax Error 346 Speed is to slow.

I have set the J6480 touse the same line that our other fax machine used before it died on Tuesday, (Ricoh fax/copier). We didn't have any problems sending out faxes until now. If the failure remains after replacing the cable, please contact your phone company for assistance. weblink Click the Search Arrow link placed to the right of the text entry box.

Disable ECM. Other reasons can include power outages and other power-related problems.The call-waiting service can cause this error. Try the fax when telephone line conditions have improved. Enable the remote diagnostics capability on the local machine, if available.

Can you receive faxes?You can test this by sending a fax to 888-HP-FAXME It will send you a return fax after several minutes.This error code is caused by:The remote machine failed Thank you! Register · Log In HP Support Forum Home > Printers > LaserJet > HP Officejet Pro 8500 A910 error 344 HP Support Forums Join in the conversation. Faxes fail intermittently or with only one fax number. Faxing is old analog technology.

Wait several minutes between the end of one transmission and the start of the next transmission. 383 ECM Disable ECM, and then try faxing again. Call the telephone provider if line conditions fail to improve. Any suggestion. Set the host machine to receive at a slower transmission speed.

I have had this fax for only a couple months and this is the first time this has happened. If the fax is transmitted successfully, continue to step 7. Reply 0 0 « Message Listing « Previous Topic Discussion Boards Open Menu Discussion Boards Open Menu Welcome to the Forum! The click, heard for an incoming call, is actually a momentary disconnect of the line.The remote user pressed the Stop key while the reception was in progress.Under rare conditions, incompatibility between

I am really fed up with HP and having to try to explain situations to someone in a foreign country where everything I say has to be repeated back to me The click, heard for an incoming call, is actually a momentary disconnect of the line.The remote user pressed the Stop key while the reception was in progress.Under rare conditions, incompatibility between First Time Here? Disconnect the phone cable from the telephone and reconnect it to the fax.

Faxes fail intermittently or with only one fax number Check the following items to find out the cause of the failure: If static is present on the phone line, fax communication Skip to Step 4: Final steps to try before contacting HP. Install the update by double clicking the downloaded file and then, follow the instructions provided by the assistant.