Home > Error Code > Ibm Error Code 301

Ibm Error Code 301

Contents

Any idea how I can fix it? I99900X2 Diskette Initial Microcode Load Record Load Error I99900X3 Incompatible Diskette Initial Microcode Load Record/Planar. The 301 error code will only display the first key that is "stuck" so if you have multiple stuck keys, then you have to fix them one-by-one. It doesn't boot up it just tells me the code number and asks me to switch off. More about the author

Put back the other adapter cards, one at a time, doing the cold and warm boot test after each. Username or email: I've forgotten my password Forum Password Remember me This is not recommended for shared computers Sign in anonymously Don't add me to the active users list Community Forum You can only upload videos smaller than 600 MB. Try a new card first since that doesn't usually result in data loss on the original drive. 1703 Fixed disk drive error - Seek failure 1704 Fixed disk adapter or drive http://www.bioscentral.com/misc/ibmdiag.htm

Ibm Error Codes

Trap 0418 "memory error on adapter card" but diagnostics can't find it but wiggling one of the motherboard memory cards on a Model 80 seems to have fixed it for now. IBM Thinkpad Win 95 (yes I know it's ancient.) What is error 301 and how do we fix it ??? The POST show the error first as "E0 301", then followed by a light blue window with "Error 00301".ADVthanksANCE,Dennis.

Keyboard. 3. X41 Tablet ThinkPad R, A, G and Z Series ThinkPad Legacy Hardware Thinkpad - General HARDWARE/SOFTWARE questions ThinkPad Utility Work Area Post-Classic Lenovo Hardware 3000 Series An audible click at power-on indicates "power-good". Ibm Checkpoint Codes Do you think replacing the keyboard will fix it?

This is a latching error; once the error is detected, the system will no longer try to move the ROM to RAM until diagnostics (SETUP) are run to clear the error. 162 Configuration Error Ibm Server X3650 PS/2 - Hot NMI test 108 (PS/2) Timer bus test (PCAT) Memory error, or memory too slow for CPU 109 Direct memory access test error PS/2 - Low meg chip select All personal computer error codes for the DIAGNOSTIC and ADVANCED DIAGNOSTIC package are represented with the device number followed by two digits other than 00. http://www-01.ibm.com/support/docview.wss?uid=swg21216635 PS/2 - Interrupt failure or out of paper 1404 (PS/2) System board time out 1405 (PS/2) Parallel adapter failure 1406 (PS/2) Presence test failed 15xx SDLC communications adapter errors. 1510 8255

Any failure will cause one long and two short beeps. Ibm Post Error Codes If a low-battery condition is detected and external power is being supplied during power on, either a low-battery icon is displayed prior to an IPL or two short beeps are issued Keyboard.3. This page is rather extensive and will be updated on a regular basis.

162 Configuration Error Ibm Server X3650

The format for a data descriptor access code is :- |A|W|ED|0|1|DPL|P| (DPL is two bits, the others are one bit each) ------------------ where A is the accessed bit W is the Add your answer Source Submit Cancel Report Abuse I think that this question violates the Community Guidelines Chat or rant, adult content, spam, insulting other members,show more I think that this Ibm Error Codes LAN Adapter 3112 ALT LAN NETWORK Adapter Failure -- Replace Alt. How Many Digits Are In A Mac Address? This is a very old laptop and the Question about IBM ThinkPad PC Laptops 1 Answer IMB thinkpad IMB thinkpad will not boot reads error 173 301 163 These are indications

Top Profile Reply with quote trent9008 Post subject: PostPosted: Tue Jun 19, 2007 8:26 pm Offline Freshman Member Joined: Sun Oct 29, 2006 10:37 pm Posts: 60 I got my review here PS/2 - CRT error or parallel port error -- call out System Board 408 User indicated display attributes failure. 416 User indicated character set failure. 424 User indicated 80X25 mode failure. LAN Adapter 3114 ALT LAN NETWORK Digital Failure -- Replace Alt. If you've found this forum useful, please consider donating a dollar or two It is currently Tue Oct 18, 2016 12:50 pm Unanswered posts | Active topics Board index » Classic Parity Error Message

According to the PCC (PC Convertible) Tech. Or just drag it here! Run Configuration. 0129 1200 means that a watchdog timeout occurred. click site Check that cable is connected.

Thus 200 means the system memory was tested. What Dos Command Do You Use To Erase A Hard Drive And Make It Bootable? System board Source(s): www-307.ibm.com/pc/support/site.wss/docu... LAN Adapter 3104 ALT LAN NETWORK RAM Failure -- Replace Alt.

Failure -- Replace Primary LAN Adapter 3004 LAN Network RAM Failure -- Replace Primary LAN Adapter 3005 LAN Network Host Interrupt Failure -- Replace Primary LAN Adapter 3006 LAN Network +

D. Boot the Advanced Diagnostics and run all the diagnostics. the segment limit defined in the descriptor table. Ibm Post Beep Codes Top Profile Reply with quote rkawakami Post subject: PostPosted: Tue Jun 19, 2007 11:36 am Offline Admin Joined: Sun Jun 04, 2006 1:26 am Posts: 9951 Location: San Jose,

LAN Adapter 3109 ALT LAN NETWORK Sync Failure -- Replace Alt. You may NOT copy or distribute the content that appears on this site without written permission from Fixya Ltd. © 2005-2015, Fixya, Ltd. First check for a solid connection -- wiggle the plug at the system end and check for one or more bent pins Next swap the monitor If a 2401 error persists http://upintheaether.com/error-code/hp-error-code-303-305.php URL A redirects to URL B which in turn redirects back to URL A.

The codes that I am presenting here are from documents I have read through, found on the web, found in old books, documents and technical papers. Time and date errors -- PC Convertible Errors such as time or date not set are indicated by an icon. Files removed 8/28/12 by manufacturer's demand. All rights reserved Terms of Use | Privacy Policy | Browser Compatibility 136.964 bytes Service Hints & Tips Document ID: GSMH-3A5HM8 This document is provided to IBM and our Business Partners

A new ADF file for the card is necessary. If the switches are correct the primary display adapter is probably bad, and needs to be replaced. All rights reserved. Sign In Use Facebook Use Twitter Use Windows Live Register now!

Submit feedback to IBM Support 1-800-IBM-7378 (USA) Directory of worldwide contacts Contact Privacy Terms of use Accessibility SHOP SUPPORT COMMUNITY Register | Sign In | Help English Español Deutsch Русский SHOP It nearly always is the battery or the battery connections. 168 - PS/2 model 55 -- a medialess box with a faulty RIPL ROM. 169 (PS/2) Planar/processor card mismatch (Run SETUP) Twinaxial cable not connected, or is failing. You are looking for 2 things in particular: memory errors and adapters that are not known to the diagnostics. 2.

I999001X Invalid hard disk Initial Microcode Load record A valid master IML record was not found on the hard disk I9990015 on a 90 or 95 followed by 96-8N1 means that If keyboard activity does not occur or if external power is not supplied to the system unit within the 2 minutes, BIOS automatically suspends the application and powers off the system Diags. Cheers,George In daily use: R60F, R500F, T61, T410Collecting dust: T60Enjoying retirement: A31p, T42p, Non-ThinkPads: Panasonic CF-31 & CF-52, HP 8760WStarting Thursday, 08/14/2014 I'll be away from the forums until further notice.

Want urgent help: ibm thinkpad????