Home > Error Code > Hyosung Error Code 565

Hyosung Error Code 565

Contents

If the error persists, the vault assembly may need to be removed to inspect / access the cash tray sensors. Use the cash dispenser diagnostic functions to check the electrical operation of the sensor. C0052 Detected notes in path after dispense Remove any notes from path, verify amount of dispensed notes. This can also be a problem with programming, check all programming (especially Dual Master Key setting and Host Processor Mode). check my blog

Excessive EMI emissions from outside source (neon sign, freezer)are likely causes. Verify that version of Mini-Bank Software matches host processor. D0057 Transaction not permitted - card Code reported by host processor. Recommended Action: This error code indicates that the system has recognized a document intended for the reject vault has reached the note transport sensor.

Atm Error Codes List

Turn the AC power OFF for a few seconds and then back ON to power cycle and reset the cash dispenser. Error Code: 310(3Ah)[:] Description: Cassette not properly installed. To clear the error code, the reject vault must be removed and inserted with the power on. Restart the cash dispenser.

Inspect for jammed Currency in the feed path and at the Exit sensor. Put more currency in the cassette and repeat the “learn note thickness” command. ADNxx Printer connection error Check cables between Printer and Mainboard, remove cables (even though they may be attached) and re-connect. Atm Error Code 3-da000(20) EOT was received as first character after the first request message was sent. 2.

C0040 Cassette removed during dispense Reset the cassette, check position of microswitch on right rear wall of cassette bay in the dispenser. Atm Error Code 3-da001 Error Code: 302(32h)[2] Description: Empty Cassette. Check with the processor. If the test dispenses are normal and the status clears, place the cash dispenser in service.

If the problem persists, replace the note transport module. Sbi Atm Response Code 70 Inspect the note transport and delivery throat make sure all belts are on track and there are no documents jammed in the transport or exit areas. Then it will go "Out of Service" for an Error 195 "Out of Paper". Open the vault and slide the dispenser back to access the exit gate area.

Atm Error Code 3-da001

It may be necessary to delete some unused graphic files from the internal flash memory. (Check out our Hyosung ATMs for sale & our Triton ATMs for sale) Error 563 Error Code: 155 Description: Electronic journal modify record failure. Atm Error Codes List Clear this error code by restarting the cash dispense or by unlocking and locking the cassettes. Hyosung Atm Error Codes Click 'Start Scan' to scan your PC for errors If errors are found, click 'Next' then 'Repair Now' to Repair the problem You may need to reboot your PC for the

Recommended Action: This error code will be generated when the following conditions occur: 1. click site C001x CDU sensor is tripped Most typically a COO11 error, this would indicate a bill jam at the exit sensor of the Cash Dispenser. Make sure all connections between the double detect module and the CMC are seated properly. If persistent, it could be a defective modem. Atm Error Code 3-da000(80)

Host hung up. Clear terminal error code. Reset the cash dispenser by turning OFF the AC power switch for a few seconds and switching it back ON. news From the Main Menu screen, select System Parameters (5) followed by Shut Down the Terminal (4).

If the problem persists, remove the main board and replace the modem. Atm Error Code 3-da000(60) Place all belts on their respective rollers and gears. Restart the operating system.

Purge the dispensing mechanism with the PURGE command from the DIAGNOSTICS function.

Clear all errors and test the dispenser by completing several TEST DISPENSES. Make sure all connectors attached to the CMC are seated in their receptacles. C0011 CDU sensor is tripped This indicates that during a dispense, the sensor located at the front of the CDU shows a blockage (CS13 or CS2). Error Code 3-da000(10) If the error clears, put the cash dispenser in service. 6.

Check the cable and connections from the docking station to the SPED board. Recommended Action: Error code valid only for units with SPED keypad device installed. Reset the cash dispenser. http://upintheaether.com/error-code/ibm-error-code-192.php This condition is also displayed on the configuration summary printout under "dispenser" as a lower case a, b, c, or d for the cassette in the low currency condition.

Reposition the microswitch if necessary. Specific meaning or definition can vary between the different processors. Replace the dispensing mechanism. C004C Miscount of notes between sensors Verify operation of exit gate.

Make sure that note qualifier and the note transport modules are mechanically aligned. Result: No money is dispensed, screen and receipt display system unavailable. If the error reoccurs the most likely causes of the problem may be note transport or CMC. Recommended Action: See recommended action for error code 138.

Error Code: 125 (7Dh) Description: Initial status check failed Recommended Action: 1. Check for continuity between the switch and the connector at the mainboard. 20005 CDU Type Mismatch CDU ROM does not match AP software. Results: No money is dispensed, screen and receipt display system unavailable Error Code: 4 Description: ERROR IN MODEM DATA Possible Cause: Unexpected data received from processor in response to message.